Page 2 of 2
Re: Looking for ideas/inspiration for rear bedroom redo 34W
Posted: Tue Feb 22, 2022 5:22 pm
by KYAvion
Not sure. I’ve often thought that would be a good idea.
Re: Looking for ideas/inspiration for rear bedroom redo 34W
Posted: Wed Feb 23, 2022 11:43 am
by BimmerRacer
I know the water heater was replaced at one point, maybe it was added. I'll look for a receipt when I get a chance, previous owner(s) kept a pretty good record of things
Re: Looking for ideas/inspiration for rear bedroom redo 34W
Posted: Wed Feb 23, 2022 2:07 pm
by KYAvion
That’d be great. Thanks.
Re: Looking for ideas/inspiration for rear bedroom redo 34W
Posted: Wed Feb 23, 2022 4:17 pm
by BimmerRacer
Nope, no receipt for this. Just that the water heater was installed in 2008
Re: Looking for ideas/inspiration for rear bedroom redo 34W
Posted: Thu Mar 10, 2022 8:35 pm
by BimmerRacer
Work in progress
Re: Looking for ideas/inspiration for rear bedroom redo 34W
Posted: Sat Mar 12, 2022 2:20 pm
by KYAvion
If you do winter camping like I do, consider applying foam board like I did in my earlier post to seal everything up.
Re: Looking for ideas/inspiration for rear bedroom redo 34W
Posted: Sat Mar 12, 2022 2:23 pm
by KYAvion
I ended up encasing the water/electrical compartment with foam board on 4 sides—top and three sides—to isolate that area from the bedroom. All foam board joints were also sealed with silicone. Same with the storage compartment door. It opens up to a storage area that is completely isolated from the bedroom to prevent any cold air from creeping in.
Re: Looking for ideas/inspiration for rear bedroom redo 34W
Posted: Tue Mar 15, 2022 8:01 pm
by BimmerRacer
Interesting idea, definitely will consider doing that. I would like to rearrange plumbing on that compartment anyway since I want to add water filtration at some point in the near future. So after that is done...
Will hopefully cut the plywood tomorrow for the platform. I have the hatchlift kit on order. They say no sideloading but I am gonna give it a try. Don't see why it wouldn't work. Also have a mattress air flow pad to prevent mold and mildew from growing under the mattress
Re: Looking for ideas/inspiration for rear bedroom redo 34W
Posted: Thu Aug 11, 2022 8:02 pm
by RichardCrane
Bimmer, If you are still looking for how to get a queen bed in your 34W, I did it and it works very well. The head is located on the driver side wall. I built a "headboard" that goes over the water heater, water and electrical cabinets. It spans that side wall and supports the head of the bed. I built a box which is slightly narrower and shorter than the mattress so there is foot room to move around the bed. The platform is gas cylinder supported and allows about 3/4 of the mattress area underneath for storage. Four large totes.
For winterizing and pump issues I move the mattress out and lift up the "headboard" for access. It's not too bad, but easier with the wife helping to move the mattress. My pump is between the water heater and water inlet cabinet. There is plenty of room there.
We were originally a rear twin arrangement. I removed the overhead cabinet on the passenger side as well as the small cabinet on the driver side against the toilet wall. There is lots of headroom all around.
Any questions let me know.
Richard Crane
1979 34W