entry step
entry step
Can someone tell me how to remove the entry step on a 1984 30R? I want to powder coat it.
Thanks,
Russ
Thanks,
Russ
-
- Posts: 763
- Joined: Wed Aug 23, 2017 9:01 pm
Re: entry step
Russ-
Here's what I remember:
Remove the sheet aluminum panning from beneath the stairs by drilling out the rivets. The stair assembly uses two pieces of angle iron for support; they are bolted to the trailer main frame and the floor. The frame provides the primary anchor point; the floor is the secondary point (I think elevator bolts here). The assembly is pretty cumbersome. A jack or stands might be in order.
I would like to find a means of attaching nylon strips where the stairs fold into its pocket.
" Faith can move mountains, but don't be surprised if God hands you a shovel.”
Silverloaf (Bob)
Dawsonville, GA
1988 30P
Silverloaf (Bob)
Dawsonville, GA
1988 30P
Re: entry step
Thank you, Bob.
I have a good jack and lumber to make blocking stands.
I have the trailer lifted enough to work under drilling out the rivets.
Best regards,
Russ
I have a good jack and lumber to make blocking stands.
I have the trailer lifted enough to work under drilling out the rivets.
Best regards,
Russ
-
- Posts: 60
- Joined: Sat Nov 30, 2019 3:10 pm